automatic round water down pipe machine or water down spout roll
forming machine are used to provide the water system for PEB
buildings. It consists of a water downpipe machine, a bending
machine and a narrowing machine for the joint of the pipes in PEB
projects. The water down pipe machine can run out squre pipe and
round pipe. Each water down pipe machine produces one
Downspout Roll Forming Machine Line. The water down pipe roll
forming machine or water down spout roll forming machine are used
to provide the water system for PEB buildings. It consists of a
downpipe, downspout roll forming machine and a bending machine and
a narrowing machine for the joint of the pipes in PEB projects
1) Steel Material: Q235, Prepainted Coil
2) thickness of material: 0.3-0.6mm
3) Feeding Width Max: 330mm
4) Capacity of Decoiler: 5000 kg
5) Inner Diameter of the Coiler: 500-600mm
6) Outer Diameter of the Coiler: 1800mm
7) Forming steps: 24 steps
8) Driving System: Chain Transmission
9) Power of main motor: 3kw, 3phases, 380V, 60Hz
10) Reducer: Cycloid Pin
11) Power of Hydraulic cutting Machine: 3kw
12) Forming Speed Max: 15m/min
13) Dimension (L*W*H) and Layout:
Manual Decoiler: 1.1m*1.8m*1.2m
Main Machine: 11m*0.7m*0.8m
Tunout Table: 4m*0.6m*0.8m
2.1.4 Process and Features
Manual Decoiler — Guiding — Roll Forming — Length
Measuring—Hydraulic Cutting—Runout Table
roll forming process
1. The machine base is whole welding treatment with hot rolled I
steel. The frame on the both sides of the machine is welded on the
machine base and we can get rid of welding stress by shaking.
2. The actuating device is cycloid pin wheel reducer with the chain
transmission. It makes the system safety reliable running no noise
and less trouble.
3. The forming roller is made of wrought steel by digital control.
Its hardness is up to HRC55 after high frequency heating treatment.
And electroplating treatment guarantees the roller’s size fineness
surface smoothness and long life service.
4. Hydraulic system made by Roxroth with hydraulic forming punch
and cut-off process makes the material effective width same.
Cut-off blade uses the material of Cr12. hardness up to HRC62 after
heating treatment. Cross-section is smooth and no barbs.
5. The machine main axle is the material of quenched and tempered
45#steel. It makes the system excellent overall properties.
6. The electric control system made in Japan with safety reliable
running highly efficiency is installed on the main machine base. It
makes the system easy operation.
7. Length of the finished product is controlled by PLC. Its feature
is easy-set and easy-operation.
Grantee and Spare Parts
ONE year Guarantee under normal usage.
The following spare parts will be supplied for free with the
1. Distance Switch: 2
2. Solenoid Valves: 1
3. Air proof Washier For the Oil Cylinder: 1
4. Bearing: 6
5. Chain: 2